By Elsie Kelly / Floor Repair Cost

The Ultimate Guide on How Replacing Damaged Laminate Flooring Planks

Are you looking for the ultimate guide on replacing damaged laminate flooring? Well, you are on the right page then. This issue commonly happens to people who have just moved in and moving their furniture but then the accident happened. Replacing damaged laminate flooring steps depend on the location of the damage. If you are replacing damaged section of laminate flooring in the middle of the room then it will require a longer procedure. Whatever your problem is, you need to read this article because we have the steps on replacing damaged laminate flooring.

Before you replace damaged piece laminate flooring, it is important to make a plan. A plan will really help you to save time, worry, and of course, money. It could be just a hardwood floor spot repair but it could also be more than a simple step of replacing damaged section of laminate flooring. As we have mentioned earlier, the location of the damaged plank would determine the process to replace damaged piece laminate flooring. If the location is near the wall then all you need to do is disconnect the planks when it comes to replacing damaged section of laminate flooring. However, if the damaged is in the middle of the room, then you need to read this article thoroughly.

The damaged is in the middle of the room

This step will be started with drilling a hole of ½-inch diameter on each corner of the plank. The right step of replacing damaged section of laminate flooring should be drilled near the end joints of the plank. Drill three more holes on each side of the plank for about 5 inches apart from each other and draw a line between the holes. It will be used for the cutting guide. Other than that, make sure that you only stick with the laminate and not the sub-floor or the underlayment. Cut along the lines from the laminate plank center to the inner holes until it reaches the drilled holes.

Lift them out or you may cut out the center area. You can remove the rest of the pieces by lifting it up and down. Before you are replacing damaged section of laminate flooring with the new plank, you need to clean the area from any excess. Before you install the new one, you need to cut both sides’ tongue by using a vibratory undercut saw. Apply some glue at the back of the board especially the joints and seams and let it dry. This is anything you need to do when it comes to replacing hardwood floor boards.

Leave a Reply

Your email address will not be published. Required fields are marked *